wood retaining wall spikes

Speed Square and Rafter Square; Pencil and 25' Tape measure; At least a 2lb hammer; String Line and tools needed to build wood retaining wall level,; 4' level; 1 2” drill (NOTE: if you use a cordless drill to drill through the timbers, it will burn up); 1 2” & 5 8” Rebar (NOTE: I use rebar because it's less expensive than Spikes ...


I have a raised bed garden plot against my house with railroad ties retaining the dirt, about 2-3 ties high. I would like ... Termites love wet areas, they eat the wood and fill the void with mud, More than you wanted to know i bet!!!! 2 · Reply ... Cut right through the large spikes that were used to hold the ties together. Cut the ties ...


Lower cost: Timbers and spikes for a wood wall cost about half as much per square foot as modular block Greater flexibility in designing a wall to fit the terrain Quicker construction (with no mixing of concrete or mortar) Better appearance-many homes and yards cry out for the soft, mellow look of wood rather than the ...


With retaining wall design the need can often dictate the material. ... and durability. Wooden timber 6" x 6"pressure treated lumber retaining walls work well, are cost effective, relatively quick and neat but require straight lines. ... Wood - wood wall systems use 6" x 6" pressure treated timbers nailed together with 10" spikes.


Generally foundations for retaining walls and free standing timber walls should be below the frost line. This is normally 4 inches ... If the dimensions of the timber are over 4x4 pressure treated wood is normally rated for ground contact. 4X6 and 6x6 timbers ... 4 inch material can be spike directly through the top. However, this ...


DIYNetwork.com has video and written instructions on how to build a timber-beam retaining wall. ... Pressure-treated lumber, especially made for this type of wall, is readily available in home improvement centers. Before beginning .... Secure this second row to the foundation row with 60d spikes, using the pre-drilled holes.


If you have access to a sawz-all also called a Tiger saw or reciprocating saw you can cut the spikes. Pry the timbers one at a time to get a little separation. Using the longest metal cutting saw blades you can get in the 14 tooth per inch range saw thru the spike. The longer blade will allow you to cut the spike ...


Mason's string. Wood Stakes. Tape Measure. Power Drill with 9 16-inch wood drill bit and extension. Circular saw. Carpenter's square. Instructions. Contractors and homeowners used to use galvanized spikes to secure the timbers together in a retaining wall. The problem with this method is that the timbers ...


Steps for building a retaining wall. ... Next, I'd set 40-penny spikes in the center of each hole location, and then remove the string so I could work (Don't remove the rebar; you'll need it later). We dug 30 4-foot deep .... If your wall is longer than the lumber you order, you'll have to splice the planks. Always ...


Because a retaining wall is going to be in contact with the ground, make sure you use lumber that's rated for ground contact. Your best choice is a ... holes with a 3-pound sledgehammer. Mark the location of the spikes on the face of the timbers with chalk so you won't hit them when you drive the spikes for the next course.


Landscape timbers are used for many outdoor projects, often as edging or stacked several rows high to construct sturdy landscape structures. Holding the timbers in place and securing them to each other requires sturdy hardware. There are several nail and spike options that work well with landscape ...


This Old House landscaping contractor Roger Cook shows how to construct a wood-timber retaining wall to create a play area. ... Then, stake the timber in place by using a small sledgehammer to drive 4-foot-long rebar spikes through the holes and into the ground. 9. When necessary, use a circular saw to cut a timber to ...